newsletterrefa.blogg.se - Netcontrol x user manual

#Netcontrol x user manual update#
#Netcontrol x user manual manual#
#Netcontrol x user manual software#
#Netcontrol x user manual free#

#Netcontrol x user manual update#

Possible firmware update in operation via Ethernet.

tates of the relay outputs are displayed with bi-colored LEDs on the front page.

Simultaneous switching of multiple outputs is prevented by automatic latency of 1 second.

#Netcontrol x user manual manual#

The automatic control of the Solar-Log™ takes precedence over the manual operation of the Solar-Log™. All circuit outputs can be switched individually on the device.Legible LED display visualizes Total Current, IP Address, Sensor Values, and Error Messages.The measurement of Power, Voltage, and Temperature (with optional sensor) is shown in section Diagnostics | Smart Energy | Status (current).Solar-Log™ Smart Relais Station 3 x 16A: 3 switchable, potential-free relay outputs with 230V (AC 16A) switching voltage.Solar-Log™ Smart Relais Station 1 x 16A: 1 switchable, potential-free relay output with 230V (AC 16A) switching voltage.The VP-II XG also provides connection ports for an electric lock (Dry contact relay outputs), exit button, sensors for door and lock monitoring, and fire alarm input. The VP-II XG is connected to the VP-II X via RS232 (or RS485 with an optional module). For security reasons, it is strongly recommended that the VP-II XG is located inside, on the secure side of the door if mounted on the un-secure side of the door, an electric lock may be opened by directly supplying a battery without verifying the user’s hand vascular biometric pattern. The VP-II XG is a Door Controller for the VP-II X Vascular Scanner. Each channel fully functions independently. The VP-II XC provides 12V DC power for the card readers connected to the Wiegand ports. The VP-II XC provides connection ports for an electric lock (Dry contact relay outputs), exit button, sensors for door and lock monitoring, and fire alarm input.

#Netcontrol x user manual software#

The VP-II XC is connected to the NetControl-X application software through TCP/IP Ethernet and operates in the same way as the VP-II X Vascular Scanner for access control functions, the only difference is that the VP-II XC validates only the card ID or PIN from the Wiegand input port, instead of the user’s hand vascular pattern. The VP-II XC is a two channel Physical Access Control System (PACS) for Wiegand input devices such as a proximity or smart card reader. NetControl-X creates or exports reports for system logs and access events with various options, including reports for time and attendance control.

Enrolled users are managed individually or by group for access granted or denied to each door or area by area by different timezone or holidays.

#Netcontrol x user manual free#

NetControl-X allows remote configuration or setup of all devices, remote door open or close, free timezone and restricted timezone per door. NetControl-X monitors and displays the operating status of all devices, doors and locks, all access events and system logs in real time. NetControl-X is a Windows based application software for managing VP-II X and/or Wiegand card readers, with an easy and convenient graphic user interface (GUI).

Up to 64 doors per location – Multiple locations can be networked.

Anti-passback function with two readers installed for in and out.

Reports for system logs and access transactions by user, group, device or period.

Auto-expiration for visitors or short term users

Convenient user management – By group, location, department or more.

Timezone control (Holidays, free access or restricted times), Access rules by user individually or group, Access granted or denied by doors and/or areas.

Powerful access control management with NetControl-X software.

Real time monitoring for all devices, locks, doors and access transactions.

Two channel access control unit (VP-II XC) for card reader connection.

Supports VP-II X Hand Vascular Scanners and/or Card readers.